NOTICE:
You have the option of sending additional digits (overdial), such as an extension number, credit card, or PIN
numbers to the phone system. If the radio is preprogrammed for live overdial, every digit entered after the call is
connected, is sent to the phone system.
If the radio is preprogrammed for buffered overdial, the digits pressed are entered into memory and then sent
when the PTT button is pressed. Press the PTT button to send either digits or voice, but not both at the same time.
Display Color Change On Channel
This feature provides visual channel identification where
users are able to have a quick visual recognition of being
on a particular channel.
Your radio must be preprogrammed to allow you to use this
feature.
When changing channels, the radio backlight on top display
and accessories (DRSM or keypad Mic) changes to the
preprogrammed color.
The radio backlight on top display changes to white and if
connected to accessories, the DRSM backlight changes to
white and the keypad mic backlight changes to green for
the following scenarios:
• When changing to or powering up on an invalid
channels such as unprogrammed channels, receiver
frequency error channel and blank channels
• The radio is in radio stun or radio lock mode
For hard key zeroize, key loading, and scan list
programming, the backlight follows the home channel
backlight color.
HAZLOC Battery Type Detection
This feature alerts the user when there is a HAZLOC
certification mismatch between the radio and the battery.
This feature supports IMPRES batteries only.
During power up, if there is a mismatch, the following
scenarios occurs:
• The radio repetitively displays Wrong Battery with red
intelligent backlight
• The radio Voice Announcement announces the
preprogrammed Wrong Battery
• The Battery icon blinks continuously
• A repetitive tone sounds
English
71
To Next Page
Loading...
Need help?
General
