Your radio prompts the first found channel if a match is
found.
1 Perform one of the following actions:
• Press the preprogrammed Channel Search
button.
• or to CSrh and press the Menu Select button
directly below CSrh.
A blinking cursor appears on the Channel Search
screen.
2 Use the keypad to type or edit your channel name.
3 To initiate searching, press the Menu Select button
directly below CSrh once the entry is done.
To exit this procedure, press the Menu Select button
directly below Cncl .
One of the following scenarios occurs:
• The display shows Searching. Once found, the display
shows the matched channel name and the radio
changes its transmission to the selected channel.
• If the radio is triggered to search for an empty entry, the
display shows Invalid entry. Repeat step 2 to search
again.
• If the entry does not match, the display shows Channel
name not found.Repeat step 2 to search again; or
press or the Menu Select button directly below Exit
to exit.
Mode Select Feature
Mode Select allows a long press to save the current zone
and channel of your radio to a programmable button,
keypad button, or a softkey; then once programmed, the
short-press of that button or softkey changes the
transmission to the saved zone and channel.
There are two methods to save the selected zone and
channel:
• Softkeys
• Programmable buttons and keypad buttons (digit 0 to 9)
NOTICE:
Your radio must be preprogrammed for you to use
this feature.
English
75
To Next Page
Loading...
