Symbologies 10 - 19
Convert UPC-E1 to UPC-A
Enable this to convert UPC-E1 decoded data to UPC-A format before transmission. After conversion, the data
follows UPC-A format and is affected by UPC-A programming selections (e.g., Preamble, Check Digit).
When disabled, UPC-E1 decoded data is transmitted as UPC-E1 data, without conversion.
EAN-8/JAN-8 Extend
When enabled, this parameter adds five leading zeros to decoded EAN-8 symbols to make them compatible in
format to EAN-13 symbols.
When disabled, EAN-8 symbols are transmitted as is.
Convert UPC-E1 to UPC-A (Enable)
*Do Not Convert UPC-E1 to UPC-A (Disable)
Enable EAN/JAN Zero Extend
*Disable EAN/JAN Zero Extend
To Next Page
Loading...
