Scanning 2 - 5
Scanning
Install and program the digital scanner (see Chapter 1, Getting Started). For assistance, contact the local supplier
or the Motorola Solutions Global Customer Support Center.
1. Aim the digital scanner at the bar code.
Figure 2-1
Scanning in Hand-Held Mode
2. Hold the trigger until the digital scanner beeps, indicating the bar code is successfully decoded. For more
information on beeper and LED definitions, see Table 2-1 and Table 2-2.
Aiming
When scanning, the digital scanner projects a red laser aiming pattern which allows positioning the bar code within
its field of view. See Decode Ranges on page 2-7 for the proper distance to achieve between the digital scanner
and a bar code.
Figure 2-2
Imager Aiming Pattern
If necessary, the digital scanner turns on its red LEDs to illuminate the target bar code.
To Next Page
Loading...
