12 - 8 Symbol DS3578 Digital Scanner Product Reference Guide
Special Commands
Pause Duration
This parameter, along with Send Pause on page 12-32, inserts a pause in the data transmission. Set the pause by
scanning a two-digit number (i.e., two bar codes) representing a 0.1 second interval in the range of 0.1 to 9.9. For
example, scanning bar codes 0 and 1 inserts a 0.1 second pause; 0 and 5 gives a 0.5 second delay. The default is
1 second. See Appendix D, Numeric Bar Codes. To correct an error or change a selection, scan Cancel on page
D-3.
Pause Duration
Begin New Rule
Scan the bar code below to start entering a new rule
.
Begin New Rule
Save Rule
Scan the bar code below to save the rule.
Save Rule
End of Message 12-102
a
-
z 12-102
{
-
~ 12-106
Table 12-1
ADF Bar Codes (Continued)
Parameter
Page
Number
To Next Page
Loading...
