Symbol LS7708 Product Reference Guide11-4
When this type of hand-held scanner is connected, program the primary scanner by scanning parameter bar codes with the primary
scanner.
To determine the type of hand-held scanner used, plug the scanner into the Scanner port. Using the hand-held scanner, scan a
parameter bar code. If the primary scanner issues a warble beep, the hand-held scanner supports the programming modes. If the
hand-held scanner issues a warble beep, it does not support these modes.
Hand-Held Laser Scanner Default Parameters
Table 11-1 lists the defaults for Hand-Held Laser Scanner Port parameters. To change any option, using the primary scanner only,
scan the appropriate bar code(s) beginning in Hand-Held Laser Scanner Options on page 11-5.
Table 11-1. Hand-Held Lase Scanner Default Parameters
Parameter Default Page Number
Programming Mode Program Primary Scanner Only 11-5
Beep After Good Decode Disable 11-7
To Next Page
Loading...
