Symbologies 13-75
Set Lengths for Discrete 2 of 5
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s) the code contains.
Lengths for D 2 of 5 may be set for any length, one or two discrete lengths, or lengths within a specific range.
When setting lengths for different bar code types by scanning single digit numbers, single digit numbers
must always be preceded by a leading zero.
One Discrete Length - This option allows decoding of only those D 2 of 5 symbols containing a selected length. Lengths are selected
from the numeric bar codes beginning on page D-1 in D. For example, to decode only D 2 of 5 symbols with 14 characters, scan D 2
of 5 - One Discrete Length, then scan 1 followed by 4. If an error occurs, or to change the selection, scan Cancel on page D-8.
D 2 of 5 - One Discrete Length
Note
To Next Page
Loading...
