Standard Default Parameters
Table A-1. Standard Default Parameters Table
Parameter Default Page Number
User Preferences
Set Default Parameter All Defaults 4-5
Beeper Tone Medium 4-5
Beeper Volume High 4-7
Beep After Good Decode Enable 4-9
Low Power Mode Low Power Blink Mode 4-10
Scan Pattern Mode Rastering 4-11
EAS Interlock Disable 4-17
Time-out Between Same Symbol 0.6 sec 4-12
Time-out Between Different Symbols 0.2 sec 4-12
Time Delay to Low Power Mode 30 Minutes 4-13
Linear UPC/EAN Decode Disable 4-15
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
