EDS-508A/505A Series User’s Manual Featured Functions
3-5
Password
Setting Description Factory Default
Old Password
(Max. 16 Characters)
Type current password when changing the
password
None
New Password
(Max. 16 Characters)
Type new password when changing the password None
Retype Password
(Max. 16 Characters)
If you type a new password in the Password field,
you will be required to retype the password in the
Retype new password field before updating the
new password.
None
Accessible IP
The EDS uses an IP address-based filtering method to control access to EDS units.
Accessible IP Settings allows you to add or remove “Legal” remote host IP addresses to prevent
unauthorized access. Access to the EDS is controlled by IP address. If a host’s IP address is in the
accessible IP table, then the host will be allowed access to the EDS. You can allow one of the
following cases by setting this parameter:
Only one host with the specified IP address can access the EDS
E.g., enter “192.168.1.1/255.255.255.255” to allow access to just the IP address 192.168.1.1.
Any host on a specific subnetwork can access the EDS
E.g., enter “192.168.1.0/255.255.255.0” to allow access to all IPs on the subnet defined by this
IP address/subnet mask combination.
To Next Page
Loading...
Need help?
General
