EDS-508A/505A Series User’s Manual Featured Functions
3-20
When configuring Port Trunking, note that:
Each EDS-505A can set a maximum of 2 Port Trunking groups (designated Trk1, Trk2). Each
EDS-508A can set a maximum of 4 Port Trunking groups (designated Trk1, Trk2, Trk3, Trk4)
When you activate Port Trunking settings, some advanced functions that you setup with the
original ports will either be set to factory default values, or disabled:
Communication Redundancy will be set to the factory default
Traffic Prioritization will be set to the factory default
Port-based VLAN or 802.1Q VLAN will be set to the factory default
Multicast Filtering will be set to the factory default
Rate Limiting will be set to the factory default
Port Access Control will be set to the factory default
Email and Relay Warning will be set to the factory default
Set Device IP will be set to the factory default
Mirror Port will be set to the factory default
You can setup these features again on your Trunking Port.
Configuring Port Trunking
The Port Trunking Settings page is used to assign ports to a Trunk Group.
Step 1: Select Trk1, Trk2, Trk3, or Trk4 from the Trunk Group drop-down box.
Step 2: Select Static, or LACP from the Trunk Type drop-down box.
Step 3: Under Member Ports and Available Ports, select the specific ports.
Step 4: Use the Up / Down buttons to add/remove designated ports to/from a trunk group.
To Next Page
Loading...
Need help?
General
