E
E. Factory Default Settings
ioLogik E1200 series products are configured with the following factory default settings:
Default IP address 192.168.127.254
Default Netmask 255.255.255.0
Communication watchdog Disable
Modbus/TCP Alive Check On
Modbus/TCP Timeout Interval 60 sec
DI Mode DI
Filter time 100 ms
Trigger for counter Lo to Hi
Counter status Stop
DO Mode DO
DO Safe Status Disable
Power on status Disable
Low width for pulse 1 ms (1.5 s for relay)
Hi width for pulse 1 ms (1.5 s for relay)
Output pulses 0 (continuous)
DIO Mode DO
AI Mode Voltage
Scaling and Slop-Intercept Disable
Password N/A
Server Location N/A
AO Mode Voltage
Scaling Disable
To Next Page
Loading...
Need help?
General
