PT-7728 User’s Manual Featured Functions
3-7
IPv4
Auto IP Configuration
Setting Description Factory Default
Disable Select this to set the PT-7728’s IP address manually.
Disable
By DHCP The PT-7728’s IP address will be assigned
automatically by the network’s DHCP server.
By BootP The PT-7728’s IP address will be assigned
automatically by the network’s BootP server.
Switch IP Address
Setting Description Factory Default
IP address for the
PT-7728
This assigns the PT-7728's IP address on a TCP/IP
network.
192.168.127.253
Switch Subnet Mask
Setting Description Factory Default
Subnet mask for the
PT-7728
This identifies the type of network to which the
PT-7728 is connected (e.g., 255.255.0.0 for a Class
B network, or 255.255.255.0 for a Class C network).
255.255.255.0
Default Gateway
Setting Description Factory Default
IP address for
gateway
This specifies the IP address of the router that
connects the LAN to an outside network.
None
DNS IP Address
Setting Description Factory Default
IP address for DNS
server
This specifies the IP address of the DNS server used
by your network. After specifying the DNS server’s
IP address, you can use the PT-7728’s URL
(e.g., www.PT.company.com) to open the web
console i
nstead of entering the IP address.
None
IP address for 2nd
DNS server
This specifies the IP address of the secondary DNS
server used by your network. The PT-7728 will use
the secondary DNS server if the first DNS server
fails to connect.
None
IPv6
Global Unicast Address Prefix (Prefix Length: 64 bits)
Setting Description Factory Default
Global Unicast
Address Prefix
The prefix value must be formatted according to
RFC 2373 “IPv6 Addressing Architecture,” using 8
colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate
the appropriate number of zeros required to fill the
undefined fields.
None
To Next Page
Loading...
Need help?
General
