PT-7728 User’s Manual Featured Functions
3-13
Parent UUID When the clock has a port in PTP_SLAVE state,
this member’s value is the value of the source-Uuid
field of the last Sync message received from the
parent of the slave port.
Clock Stratum The stratum number describes one measure of the
quality of a clock. Each clock is characterized by a
stratum number used by the best master clock
algorithm as one parameter of clock quality.
4
Clock Identifier Properties of the clock. DFLT
PTP Port Settings
Setting Description Factory Default
Port Enable Enable or disable PTP port operation. None
Port Status Display PTP port real status. PTP_DISABLED
System File Update—By Remote TFTP
The PT-7728 supports saving your configuration or log file to a remote TFTP server or local host.
Other PT-7728 switches can also load the configuration at a later time. The PT-7728 also supports
loading firmware or configuration files from the TFTP server or a local host.
TFTP Server IP/Name
Setting Description Factory Default
IP address of TFTP
server
This specifies the IP address or name of the remote
TFTP server. This must be specified before
downloading or uploading files.
None
Configuration Files Path and Name
Setting Description Factory Default
Max. 40 characters This specifies the path and file name of the
PT-7728’s configuration file on the TFTP server.
None
Firmware Files Path and Name
Setting Description Factory Default
Max. 40 characters This specifies the path and file name of the
PT-7728’s firmware file.
None
To Next Page
Loading...
Need help?
General
