MR MSENSE DGA 2/3 - 3 IT security

3 IT security
Maschinenfabrik Reinhausen GmbH 202314 4001150/12 ENMSENSE
®
DGA 2/3
3 IT security
Observe the following recommendations to operate the product safely.
▪ Ensure that only authorized personnel have access to the device.
▪ Only use the device within an ESP (electronic security perimeter).
▪ Ensure that the device is only operated by trained personnel who are fa-
miliar with IT security.
▪ All protocol interfaces (ModbusRTU, ModbusTCP, DNP3TCP and
IEC61850-8-1MMS) only have read-access to the MSENSE®DGA 2/3.
Changing parameters or data via this is not possible.
▪ Access to the parameterization via the MESSKO®MSET parameteriza-
tion software can be protected through the use of passwords. Change the
passwords regularly.
Observe the information of access rights, user levels and password settings
in the MESSKO®MSET parameterization software operating instructions.