MR MSENSE DGA 2/3 - 10.2 Maintenance

10 Maintenance
Maschinenfabrik Reinhausen GmbH 202368 4001150/12 ENMSENSE
®
DGA 2/3
10.2 Maintenance
The device determines the point in time when maintenance is to be per-
formed based on the operating parameters. Maintenance ensures the long-
term accuracy of the measured results. The maintenance information is is-
sued via the event database of the MESSKO®MSET parameterization soft-
ware and can be transmitted to a SCADA system via Modbus. Furthermore,
signaling via relay outputs can also be configured. The device version with
display shows the maintenance information directly on the display.
In case of a maintenance signal, proceed as follows:
Event Display Recommended action
Maintenance in 6months Maintenance 6months Contact MR Technical
Service
Maintenance required Maintenance required Contact MR Technical
Service
In case of a maintenance signal, please contact the Technical Service of
Maschinenfabrik Reinhausen GmbH (MR) immediately:
Maschinenfabrik Reinhausen GmbH
Technical Service
Postfach 12 03 60
93025 Regensburg
Germany
Phone: +49 941 4090-0
E-mail: service@reinhausen.com