MR MSENSE DGA 2/3 - 6.2.1 Preparing the transformer and ball valve

6 Mounting
Maschinenfabrik Reinhausen GmbH 2023 254001150/12 EN MSENSE
®
DGA 2/3
6.2.1 Preparing the transformer and ball valve
ü A flange is mounted on the transformer that matches the device ball valve
flange.
1. Carefully remove the ball valve from the packaging and protect it against
damage.
2. Remove the fixing screw from the dummy plug.
Figure5: Unchaining the dummy plug
3. Release the clamp connection.
Figure6: Releasing the clamp connection