MR MSENSE DGA 2/3 - Page 26

6 Mounting
Maschinenfabrik Reinhausen GmbH 202326 4001150/12 ENMSENSE
®
DGA 2/3
4. Pulling the dummy plug out
Figure7: Pulling the dummy plug out
Package the dummy plug and store safely in case the device is to be re-
moved at a later date.
5. Turn the ball valve lever to the "closed" position.
Figure8: Closing the ball valve
NOTICE
Missing or incorrectly positioned round gasket
Non-tight seal and possible oil leakage.
► Ensure that all round gaskets remain in position in the ball valve when lu-
bricating.