MSA SOLARIS - Toxic Gas Measurements

Toxic Gas Measurements (FIGURE 2-4)
• The Solaris Multigas Detector can be equipped to detect:
• Carbon Monoxide (CO) and/or
• Hydrogen Sulfide (H
2
S) in the atmosphere.
• When the alarm setpoint is reached for Carbon Monoxide (CO)
and/or Hydrogen Sulfide (H
2
S):
• Alarm Sounds
• Alarm Lights flash
• PPM CO or PPM H
2
S flag above the concentration flashes.
If the Toxic Gas alarm condition is reached while using the
instrument as a personal or area monitor, leave the area
immediately; the ambient condition has reached a preset
alarm level. If using the instrument as an inspection device,
do not enter the area without proper protection. Failure to
follow this warning will cause over-exposure to toxic gases,
which can result in serious personal injury or death.
Solaris Multigas Detector
Equipped with an NO
2
Sensor Only
• The Solaris Multigas Detector can be equipped to detect NO
2
.
Units are identified:
• at turn-ON by displaying 'TOX2 NO2'
• during continuous operation, by scrolling 'Solaris NO2' across the
display.
""
WARNING
Figure 2-4. Instrument in Toxic Gas Alarm
2-9