MSA SOLARIS - Page 32

7. LEL/CH
4
Setup
• Sensor ON/OFF (turns the sensor ON or OFF)
• Display Combustible Gas Type?
• Methane
• Pentane
• Hydrogen
•Propane
• LEL or Ch
4
mode (displays % LEL (for any gas)
or % CH
4
(for Methane only)
• Low Alarm (sets the low combustible alarm)
• High Alarm (sets the high combustible alarm)
• Cal Gas (sets the expected combustible calibration gas)
8. O
2
Setup
• Sensor ON/OFF (turns the sensor ON or OFF)
• Low Alarm
• High Alarm
9. CO Setup
• Sensor ON/OFF (turns the sensor ON or OFF)
• Low Alarm (sets the low CO alarm)
• High Alarm (sets the high CO alarm)
• STEL Alarm (if enabled) (sets the STEL CO alarm)
• TWA Alarm (if enabled) (sets the TWA CO alarm)
• Cal Gas (sets the expected CO calibration gas)
10.TOX2 Setup (H
2
S or NO
2
)
• Sensor ON/OFF (sets TOX2 sensor ON or OFF)
• Low Alarm (sets the low TOX2 alarm)
• High Alarm (sets the high TOX2 alarm)
• STEL Alarm (if enabled) (sets the STEL TOX2 alarm)
• TWA Alarm (if enabled) (sets the TWA TOX2 alarm)
• Cal Gas (sets the expected TOX2 calibration gas)
3-4