What should I do if my MSA Gas Detectors show Channel Error?
If your MSA Gas Detectors display a 'Channel Error', it indicates an error in the mA output system. Reset the sensor. Verify sensor configurations (if different from default values), then recalibrate the sensor. If the issue persists, replace the sensor.
What does it mean if my MSA Gas Detectors have Life and Health Fault?
If your MSA Gas Detectors display a 'Life and Health Fault', it means the sensor is at the end of its life. Try to recalibrate the sensor to extend its life. If the error doesn't clear after recalibration, replace the sensor.
What does it mean if my MSA Gas Detectors show Sensor End of Life Fault?
If your MSA Gas Detectors show a 'Sensor End of Life Fault', it means the sensor is at the end of its life. Try recalibrating the sensor. If the error persists after recalibration, replace the sensor.
What to do if my MSA Gas Detectors show ACT Fault?
If your MSA Gas Detectors display an 'ACT Fault', it indicates an out of range measurement. Replace the sensor.
What to do if my MSA Gas Detectors have Zero Calibration Fault?
If your MSA Gas Detectors indicate a 'Zero Calibration Fault', it means the sensor did not pass the Zero calibration operation. Acknowledge the fault to revert to the previous calibration. This fault can be caused by: 1. A bad sensor 2. The sensor is trying to zero while span gas is being applied. Check the zero gas cylinder is correct and within expiration date. If not using zero gas, ensure that there is not a background concentration of the target gas in the atmosphere. Go through the calibration process again after verifying. If the fault persists, replace the sensor.
Guidelines for proper and intended use of the gas monitor.
Details on the warranty period and terms for the ULTIMA X5000.
Overview of the OLED display and status LEDs.
Explanation of the tool-free maintenance and operation features.
Details on sensor verification and self-monitoring capabilities.
Describes the process for easy sensor replacement without powering down.
Critical safety precautions before installing the device.
Guidance on different methods for physically mounting the device.
Instructions for safely connecting the device to a power source.
Initial power-on sequence and sensor warm-up times.
How to navigate and change device settings.
Accessing and viewing device status information.
Required tools and gas cylinders for calibration.
Recommended schedule for performing sensor calibrations.
Step-by-step guide for performing zero calibration on sensors.
Procedure for cleaning the optical windows of the XIR PLUS sensor.
Instructions for safely replacing XCell sensors.
Common fault messages and their resolutions.
General| Ingress Protection | IP66/67 |
|---|---|
| Sensors | Electrochemical, infrared |
| Communication | HART, Modbus |
| Target Gases | Combustible gases, toxic gases, oxygen |
| Approvals | ATEX, IECEx, UL, CSA, SIL 2 |
To Next Page
