Print last and repeat
Print only the last message from the sender. The printer will continue to print the last message until it
receives new messages.
For example, if the printer receives 5 messages from the sender, the printing result will be:
Data type
Choose the POD data type: Raw data, JSON and Customize.
Connection
TCP/IP
Choose TCP/IP as the method for sending and receiving POD data.
COM
Choose COM as the method for sending and receiving POD data.
INPUT
Choose INPUT as the method for sending and receiving POD data.
Barcode Scanner
Connect with Barcode scanner to use this function.
Install the Barcode scanner to the controller via USB port. The printer will read and print data received from
Barcode scanner.
Response POD Data
ENABLE this function to follow response POD data was printed.
Response POD Command
ENABLE this function to receive POD command response from printer to 3
rd
party.
Controller Port
The communication port of the controller.
Rule
Split Character
For POD, choose the character that is used to divide the senders data into multiple data fields: Tab (‘\t’),
Unit Separator, Space (‘ ’), Hash (‘#’), Mod (‘%’), And (‘&’), Star (‘*’),
Comma (‘,’), Dot (‘.’), Colon (‘:’), Semi Colon (‘;’), Question (‘?’), AT (‘@’).
Encoding
For POD, choose the encoding format of the sender’s data: ASCII, IBM EBCDIC Germany, IBM EBCDIC
Italy, IBM EBCDIC Arabic, IBM EBCDIC Hebrew, IBM EBCDIC Thai, Russian Cyrillic,...
Monitor
On POD software, this function will allow user get realtime printer informations as: Speed, Printer status,
Printed pages, Printhead status,…
To Next Page
