USER MANUAL V1.0 | Updated January 19, 2019 36
Print Mode
Sensor mode and Continue mode.
From the Settings menu, use the arrow keys to go to Print Mode and press Enter. Select Mode
and press Enter to select Sensor or Continue mode.
Sensor mode
Machine is triggered by sensor to print.
Go to Mode and press Enter to select Sensor mode and use arrow keys to move to other
settings.
Input value at Repeat to set the number of prints to be repeated on the same object. Press
Enter to confirm and go to the next setting. Valid values vary from 0 to 99.999.
Input value at Delay to set distance between the prints. Valid values vary from 10 to 10,000.
Invalid values results in error.
Continue mode
Go to Mode and press Enter to select Continue mode and use arrow keys to move to other
settings.
Input value at Delay to set distance between the prints. Valid values vary from 5 to
10,000mm. Invalid values results in error.
Immediate: print continue without sensor signal.
Level: print continue with sensor signal.
Unit
Select your desired measurement units inches or mm.
From the Settings menu, use the arrow keys to go to Unit and press Enter. Move to your desired
measurement, press Enter to select.
Wi-Fi
Connect machine to Wi-Fi network.
From the Settings menu, use the arrow keys to go to Wi-Fi, press Enter. Use and arrow keys
to turn ON or turn OFF Wi-Fi (see at Quick Guide).
Update Font
Update different fonts and character sizes for Machine. There is one font at a time on
Machine.
Machine supports the following fonts while working with wireless keyboard.
To Next Page
Loading...
