To Next PageTo Next PageWhat does 'Target Rate is out of reach' mean on Muller Elektronik Controller?
If the Target Rate is out of reach on the Muller Elektronik Controller, it means the control system cannot maintain the target rate. To fix this, drive at a constant speed or control the target rate manually.
Why is the rotational speed too low on the Muller Elektronik SLURRY 3.0 application pump?
If the rotational speed of the application pump is too low on the Muller Elektronik Controller, it's because the rotational speed of the pump is too low. Increase the rotational speed to resolve this.
Why is the rotational speed too high on the Muller Elektronik SLURRY 3.0 Controller application pump?
If the rotational speed of the application pump is too high on the Muller Elektronik Controller, it's because the rotational speed of the pump is too high. Reduce the rotational speed to resolve this.
How to resolve overpressure in top link on Muller Elektronik SLURRY 3.0 Controller?
If there's overpressure in the top link of your Muller Elektronik Controller, it's because the pressure in the top link is too high. Set the optimal pressure to resolve this.
Why is fold/unfold forbidden at this speed on my Muller Elektronik Controller?
If fold/unfold is forbidden at the current speed on the Muller Elektronik Controller, it's because the driving speed is too high for folding/unfolding. Come to a stop or reduce the speed for folding/unfolding.
What to do if the application pump is blocked on Muller Elektronik SLURRY 3.0?
If the application pump is blocked on the Muller Elektronik Controller, it's because the pump is blocked or switched off. Check the pump to resolve this.
What causes overpressure in divider on Muller Elektronik SLURRY 3.0?
If there is overpressure in the divider on the Muller Elektronik Controller, it's because the divider is clogged. Remove the obstruction to resolve this.
Why does my Muller Elektronik SLURRY 3.0 Controller say maximum speed exceeded?
If the maximum speed is exceeded on the Muller Elektronik Controller, it's because the permissible maximum speed for the steering system has been exceeded. To resolve this, observe the permissible maximum speed for the steering system.
Why is the gear rotational speed too high on my Muller Elektronik Controller?
If the rotational speed of the gear is too high on the Muller Elektronik Controller, it means the gearbox rotational speed is too high. Reduce the rotational speed to resolve this.
What to do if top link is unlocked and speed is too high on Muller Elektronik SLURRY 3.0 Controller?
If the top link is unlocked and the speed is too high on the Muller Elektronik Controller, it's because there is still pressure on the top link, which can cause problems when driving on roads. Unlock the top link or put it in float position.
General| Brand | Muller Elektronik |
|---|---|
| Model | SLURRY-Controller 3.0 |
| Category | Controller |
| Language | English |
