multicomp pro MP720105 User Manual

7.Communication with PC
Figure 7-9 Set the network parameters of the computer
(8) Set the network parameters of the Oscilloscope Software. Run the software on the
computer; choose the "Ports-settings" of the "Communications" menu item. Set "Connect
using" to LAN. Set IP and Port to the same value in the oscilloscope. If you can get data
normally, the connection is successful.
Figure 7-10 Set the network parameters of the Oscilloscope Software
121

multicomp pro MP720105 Specifications

General

Brand	multicomp pro
Model	MP720105
Category	Test Equipment
Language	English