multicomp pro MP720105 User Manual

11.Technical Specifications
11. Technical Specifications
Unless otherwise specified, the technical specifications applied are for
Multicomp Pro dual-channel series only, and Probes attenuation set as 10X. Only if
the oscilloscope fulfils the following two conditions at first, these specification
standards can be reached.
 This instrument should run for at least 30 minutes continuously under the
specified operating temperature.
 If change of the operating temperature is up to or exceeds 5℃, do a
"Self-calibration" procedure (see "How to Implement Self-calibration" on P14).
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Oscilloscope
Performance Characteristics Instruction
Bandwidth
MP720105
200 MHz
MP720106
8 bits mode
200 MHz
12 bits mode
150 MHz
14 bits mode
20 MHz
MP720107
Vertical Resolution (A/D)
MP720105
MP720106 14 bits
MP720107
Channel 2 + 1 (External)
Waveform Refresh Rate 75,000 wfms/s
139
300 MHz
8 bits
8 bits
(Use gray scale to indicate frequency of
occurrence, where frequently occurring
waveform are bright.)
MP720105
MP720106
MP720107
Support
MP720105
MP720107
Not support
MP720106
Support (the touchscreen
should be configured)
Magnifier Function
(The magnifier window can display
the magnified wave of the wave
selection.

multicomp pro MP720105 Specifications

General

Brand	multicomp pro
Model	MP720105
Category	Test Equipment
Language	English