In the bottom line the “0” flashes. Use the 3-D digi-
adjustor to select the memory in which the new model
is to be stored. Memories already containing data are
not offered as you leaf through, i.e. you cannot acci-
dentally overwrite a model.
Press the 3-D digi-adjustor briefly r to confirm your
selected memory. This takes you to the menu for enter-
ing the model name.
Note: interrupting (no new model)
If you accidentally find yourself at this menu point, or
have selected the wrong model type, enter “0” as the
memory, and the input process is interrupted.
A long press on the 3-D digi-adjustor ª also concludes
the process, and returns you to the INFO 1 display.
A further brief press r on the 3-D digi-adjustor activates
input mode. The first character flashes.
The default model name is <HELI>, but this can be
changed to anything you like.
Changing the model name
Use the 3-D digi-adjustor to search for the desired
character. The following characters are available:
0 to 9, :, /, <, -, >, ?, space, A to Z
Press the 3-D digi-adjustor again briefly r.
The second character now flashes, and can be se-
lected in the same way.
Repeat this procedure until you have entered all six
characters. Press the 3-D digi-adjustor briefly r after
the sixth character to complete the name input process.
Note: interrupting the name input process
If the model name has less than six characters, you
can interrupt the process with a long press ª on the 3-
D digi-adjustor. This returns you to the INFO 1 display.
The new model is now stored in the memory, and you
are returned to the “NAME” menu. You can move on to
other menus via “EXIT”; alternatively a long press ª
takes you directly to the INFO 1 display.
16.3.2. Setting the stick mode
(which stick controls which function?)
Menu: (
SETUP, MODEL) MODE
The stick mode determines which transmitter controls
operate the functions ROLL (aileron), PITCH-AXIS
(elevator), YAW (rudder), and COLLECTIVE PITCH.
Four modes are available:
Mode left stick right stick
ÙÚ Ù Ú
1 Yaw Pitch-axis Roll Coll. pitch
2 Yaw Coll. pitch Roll Pitch-axis
3 Roll Pitch-axis Yaw Coll. pitch
4 Roll Coll. pitch Yaw Pitch-axis
Study the table to locate the stick mode you wish to
use, then set the appropriate mode.
Moving to the “MODE” menu:
4 to MENU, r (SETUP appears),
r (MODEL appears), r (MODE appears),
r
The current stick mode flashes. Use the 3-D digi-
adjustor to set your preferred mode.
A brief press r on the 3-D digi-adjustor concludes the
process. The value is stored.
16.3.3. Transmitter controls for the HELI type
The picture below shows which functions are controlled
by the individual transmitter controls in the HELI model
type.
Switch functions
Teacher button TRAINER Emergency throttle OFF
THR-CUT
Auto-rotation A-ROT Direct Throttle DTC
Dual-Rate D-R Switching flight
phases 1 - 3
PH (Î 16.10.)
Slider functions
AUX 1 Throttle limiter
THR-LIMIT
16.3.4. Setting the rotor head type
Menu: (
MIXER, KOPF) TYP
You have already determined the rotor head type for
your model helicopter In section 16.2.1., but it has not
yet been entered in the transmitter. The head type
must now be set for the current model memory.
To Next Page
Loading...
Need help?
General
