Part Number: WBL-95-156 REV002 43
Section 4 Maintenance
Blender Cleaning Cup
1. Place the 20oz cup filled with dish detergent cleaner
solution, that was set aside earlier, into the shuttle.
2. Press the Confirm button to start the cleaning process.
Blender Sanitizing Cup
1. Once the shuttle has returned to the dispense area,
remove cup from the shuttle and pour down the drain
in the dispense area.
2. Place the 20oz cup filled with sanitizer solution, that
was set aside earlier, into the shuttle.
3. Press the Confirm button to start sanitizing process.
Clean Drain
1. Once the shuttle has returned to the dispense area,
remove cup from the shuttle and dump down the drain.
2. Use key to unlock and open the top door.
3. Pour 1 Gal / 4L of hot water (113 F / 45 C) down the drain.
4. Pour any remaining cleaner/sanitizer solution from pray
bottle down drain.
Daily Cleaning Complete
1. Daily cleaning has been completed.
2. Unit will need to be cleaned again in 7 days.
3. Return supplies to cleaning kit.
4. Ensure top and bottom doors are closed and locked
5. Press Confirm button.
NOTE: By pressing Confirm button, the daily cleaning has been
completed and the daily timer has been reset for 24 hours.
To Next Page
Loading...
Need help?
General
