42 Part Number: WBL-95-156 REV002
Maintenance Section 4
Sanitize Blender
1. Spray and wipe the blender shaft and top of blender
cap with a clean towel saturated with sanitizer solution.
2. Lift the blender cap, spray and wipe down top of blade
housing and bottom of blender cap.
Important
Allow to air dry, DO NOT wipe off sanitizer!
3. Press Confirm button when done to raise blender.
Sanitize Front Door Section
1. Spray and wipe all surfaces of the door and areas to
the right of the door with a clean towel saturated with
sanitizer solution.
Important
Allow to air dry, DO NOT wipe off sanitizer!
2. Press Next when ready to continue.
Install Splash Guard & Shuttle
1. Retrieve splash guard, rail, and shuttle from the kitchen.
2. Place rail back by tucking left edge under tab, place
down on tray, and shift to the right.
3. Place shuttle by placing in blender area; tuck front
bottom lip in rail channel and tilt back toward unit past
blender cap until fully resting on rail.
4. Move shuttle all the way to the right in the dispense area.
5. Slide clear blender chamber splash guard back into top
door opening on the right.
Important
Make sure the clear splash guard is properly snapped in
to place or the blender will not work!
6. Close top door, lock the door using key, then press
CONFIRM button.
Shuttle Calibration
1. Did the shuttle move from left to right and then return
to the dispense area?
2. Press YES or NO to continue.
NOTE: If NO, the screen will prompt you to make sure the
shuttle is in place to continue.
To Next Page
Loading...
Need help?
General
