48 Part Number: WBL-95-156 REV002
Maintenance Section 4
Sanitizer Instructions
1. Remove the hose from the cleaning bucket.
2. Place the hose into the bucket with sanitizer solution.
3. Press the Confirm button to start the sanitizing cycle.
First Sanitation Process
The screen will display the line sanitizing progress for each
line then automatically proceed to the Soak Time Screen.
First Sanitizing Soak
After the sanitizer solution has run through and flooded all
product lines the unit will go into a hold displayed on screen.
Once the timer finishes counting down it will automatically
proceed to sanitize the lines and hold a second time. After
the second hold time the unit will proceed to the Rinse
Process.
Final Rinse Process
The screen will display the line rinsing progress for each line
where fresh water is flushed through all product lines then
prompt the user to proceed to Prime lines with product.
Auto Prime
1. Remove the hose from bucket.
2. Disconnect the hose from CIP Pump Connector.
3. Do NOT remove bottomless cleaning cup.
4. Press Confirm button to proceed to Auto Prime the
lines with product.
AUTO PRIME
The screen will display Auto Prime progress for each line
until all lines have been primed.
Auto Prime Complete
1. Remove bottomless cleaning cup from shuttle.
To Next Page
Loading...
