Part Number: WBL-95-156 REV002 49
Section 4 Maintenance
Remove Splash Guard & Shuttle
1. Manually move shuttle all the way to the blend area on
the right.
2. Tilt top of shuttle forward towards front of unit past
blender cap to remove.
3. Grasp rail, shift to the left, and lift right edge to clear tab.
4. Shift rail slightly towards the right to clear left tab and
lift out to remove.
5. Unlatch and remove blending chamber splash guard
from top door.
6. Press Next when ready to continue.
Clean & Sanitize Blender Splash Guard and Shuttle
Important
DO NOT put the shuttle or rail in dishwasher or power soaker.
DO NOT use abrasive cleaners or pads on the clear splash
guard, this will scratch and damage the guard.
1. Take the blender splash guard, shuttle, and rail to the kitchen.
2. Wash, rinse, and sanitize the splash guard, shuttle, and rail
in the three compartment sink making sure to remove any
product residue.
3. Allow all pieces to air dry.
4. Press Next when ready to continue.
Clean Dispense Area
n
Warning
NEVER use a scrub brush on flavor dispenser nozzles -
This will damage the machine!
1. Using the spray bottle filled with cleaner solution
thoroughly spray down the dispense nozzle and drain area.
Important
Make sure to saturate the dispense nozzles and ice
dispense opening with cleaning solution.
2. Using a clean towel saturated with dish detergent
cleaner solution, wrap the towel around your finger and
thoroughly swab out each flavor dispense nozzle making
sure no product residue is left around the openings.
3. Wipe the dispense and drain area with a clean towel
saturated with dish detergent cleaner solution.
4. Completely wipe down dispense and drain area with
clean sanitized towel.
5. Press Next when ready to continue.
Clean Blender Area
n
Warning
The blender station contains sharp moving parts. Wear
gloves to protect hands.
1. Spray and wipe the blender and area with a clean towel
saturated with cleaner solution.
2. Press Confirm button to lower the blender.
To Next Page
Loading...
Need help?
General
