54 Part Number: WBL-95-156 REV002
Maintenance Section 4
Clean Refrigerated Base
1. Use key to unlock and open bottom door.
2. Using the spray bottle with cleaner/sanitizer solution,
spray all the surfaces in base including door and gasket
with solution.
3. With a clean disposable towel, wipe clean all the
surfaces in base including door and gasket.
4. Press Next when ready to continue.
Sanitize Refrigerated Base
1. Using the spray bottle with cleaner/sanitizer solution,
spray all the surfaces in base including door and gasket
with solution.
2. Saturate a disposable towel with solution from spray
bottle and wipe down surfaces in base including door
and gasket.
3. Do not wipe sanitizer off and allow to air dry.
4. Press Next when ready to continue.
Prepare Refrigerated Base
1. Make sure all 8 product flavor bags present and connected.
n
Warning
All 8 slots need either a product bag or a cap over the
product sanitation fitting of the motor assembly in
order to clean or water/cleaner/sanitizer will flow into
the cabinet during the cleaning process.
1. Install a product flavor bag or a cap over product
sanitation fitting if slot is empty.
2. Repeat for each empty slot.
3. Close bottom door.
4. Press Next when ready to continue.
Prepare to Clean
1. Open the top door.
2. Connect the cleaning hose to the CIP pump connector.
3. Place the other end into the shaker jug containing the
cleaner/sanitizer solution making sure it reaches the
bottom of the jug.
4. Place the bottomless cleaning cup in shuttle.
5. Press Confirm button to start the Rinse/Cleaning Process.
To Next Page
Loading...
Need help?
General
