Section 40 00-02-0716
2013-06-03 - 4 -
There are three positions displayed on this line: AUTO and MAN. When a start
signal is active, the display will change to show the start option being used in
place of Auto or MAN: “SINGLE CONTACT START”, “FLOAT START”,
“MOMENTARY START”, “PRESSURE START”, “LEVEL START”, “TEMP
START”, “CLOCK START”, “SCADA START”
This line shows the present day of the week.
This line displays the present date.
This line shows the present time.
The following are the different states the controller will execute during the auto
sequence:
To Next Page
Loading...
