Cube67 System Manual
19 V 2.5
3.1.13 Preterminated 7/8“ Power Cables
The Cube67 System is supplied with voltage via a 7/8" connector. The voltage supply for the sensors and
actuators can be fed in separately. The ground of both supply voltages is connected internally. The
operating voltage of the Cube67 components is drawn from the sensor power supply.
Table 3-10: 7/8“ power cable
in steps of 0.5 m
For more information on 7/8“ power cables, please refer to our catalog or our online
shop at:
onlineshop.murrelektronik.com
3.2 Internal System Connection
Use only our preterminated lines for the internal system connection.
CAUTION:
Inverting Cube67 I/O modules in a system may result in injury or serious damage to
humans and/or material.
When comparing planned and actual configuration, the Cube67 system is basically
unable to distinguish between identical or replaceable modules. Therefore, it is
important to label Cube67 system cables and Cube67 I/O modules clearly.