nal von minden Reactif Touch - Powering down

8
nal von minden GmbH · Manual
Reac f Touch
Powering Down
Before turning the analyzer off , always ensure that there is no strip on the test table and
that the table and insert are clean. Press the On/Off bu on for at least 5 seconds. The
test table will retract into the analyzer. If there is no strip on the test table, the door will
close and the analyzer will switch off .
When the analyzer is turned on for the fi rst  me, the Start-Up Wizard will be displayed
for a quick setup procedure. Refer to Sec on 5 Start-Up Wizard for further instruc ons
regarding the Start-Up Wizard.