NAPCO Gemini GEM-P816 User Manual

NAPCO Security Systems
R
GEM-P816 Programming Instructions

Page 11
DIRECT ADDRESS OVERVIEW
Direct Address Programming allows you to go directly to the address locations (up to 2287) and change the data entries
manually in order to customize your control panel options. Whereas the Easy Menu Program Mode guides you through
limited selections to get you started, Direct Address Program Mode allows you to change all options directly. It con-
sists of up to 2287 address locations each with data entry locations as shown in the following diagram (below left). The
data entry location accepts data in one of three formats: Binary, Decimal and Hexadecimal (explained below in
"Address Mode Displays"). The following diagram (below right) illustrates a Decimal format data entry location (using
a GEM-RP1CAe2 keypad).
ADDRESS MODE DISPLAYS
There are three types of address displays when programming in Direct Entry Program Mode, as follows:
A) Binary (Bit) Format Example
Settings (such as Zone Features) display and accept data in "number" format. For example, Zone Features are
turned on by the pressing of keypad buttons 1 through 8, with the activated Zone(s) displaying the corresponding
decimal digit (replacing deactivated zones which are signified by dashes).
EXAMPLE: BIT Format with the GEM-RP1CAe2: Program Zones 2, 4, 5 and 7 as Exit/Entry Follower Zones.
DETERMINE THE DATA ENTRIES
1. Referring to ZONE FEATURES in the Programming Worksheets that follow, the Exit/Entry Follower for Zones 1
through 8 are located at address 0916.
DATA ENTRY
LOCATION
ADDRESS
LOCATIONS
0000
0000
TO
2287
DATA ENTRY LOCATION:
(One of three formats):
• Binary (Bit)
• Decimal
• Hexadecimal
DIRECT ADDRESS PROGRAM MODE
GEM-RP1CAe2 Keypad Display Example
0000 060 D
1 2
= ADDRESS LOCATION
1
2 = DATA ENTRY LOCATION
0916 - - - - - - - - B 0916 - 2 - 4 5 - 7 - B
DATA ENTRY LOCATION:
Binary (Bit) Format
• No zones yet activated
Address
0916
"Exit/Entry
Follower"
Address
0916
"Exit/Entry
Follower"
DATA ENTRY LOCATION:
Binary (Bit) Format
Press 2 4 5 and 7 in order to acti-
vate Zones 2, 4, 5, and 7. (The "B" on the right indi-
cates "Binary" format). Because "bit numbers"
range from 0-7, these "option numbers" 2,4,5 and 7
correspond to "bit numbers" 1,3,4 and 6, respec-
tively.

NAPCO Gemini GEM-P816 Specifications

General

Brand	NAPCO
Model	Gemini GEM-P816
Category	Control Panel
Language	English