NAPCO Gemini GEM-P816 - Table of Contents

NAPCO Security Systems
R
GEM-P816 Programming Instructions

Page 3
TABLE OF CONTENTS
Refer to accompanying GEM-P816 Installation Instructions (WI994) for installation information.
SYSTEM PROGRAMMING OPTIONS .....................................4
INTRODUCTION ................................................................. 4
DOWNLOADING FROM A COMPUTER .............................4
EASY MENU DRIVEN PROGRAM MODE ...............................5
Dealer Program - Preliminary Information ...........................5
Accessing Dealer Program Mode ........................................5
Customizing a Default Program ...........................................5
GEM-RP1CAe2/GEM-K1CA Easy Program Menu .........6
Total Number of Zones in Area 1 ................................6
Fire Zones in Area 1 ...................................................6
2-Wire Fire Zones in Area 1 ........................................6
Local or Central Station Reporting System .................6
Exit/Entry Zones in Area 1 ..........................................6
Interior Zones in Area 1 ..............................................6
24 Hour Zones in Area 1 .............................................6
Chime Zones in Area 1 ...............................................7
Chime 2 Zones in Area 1 ............................................7
Exit/Entry2 Zones in Area 1 ........................................7
50 mS Loop Response Zones .....................................7
Aux Output Activated on Alarm Zones ........................7
Sensor Watch Zones .................................................7
Keypad Sounder On Alarm Zones ..............................7
Auto Bypass Re-entry Zones ......................................7
Enable No EOLR Zones .............................................7
Enable Telco Line Fault Test? ....................................7
Enable Burg Output Chirp on Keyfob? ........................8
Enable SIA CP-01 Features? ......................................8
Number of Keypads in Area 1 ....................................8
Central Station Receiver 1 Telephone Number ...........8
Central Station Receiver 1 Account Number ...............8
Central Station Receiver 1 Format ..............................8
Enter User Codes ......................................................8
RF Transmitter Points .................................................9
Keyfob Transmitters as Arm/Disarm & Control
Devices ................................................................ 9
Keyfob Transmitters as Zone Input Devices .............10
Enter Zone Descriptions ...........................................10
Enter Date ................................................................10
Enter Time ................................................................10
Dealer Code ..............................................................10
Test Timer ................................................................10
Clear Dealer Program ...............................................10
Cold Start ..................................................................10
DIRECT ADDRESS PROGRAM MODE .................................11
Direct Address Overview ...................................................11
Address Mode Displays .....................................................11
Binary (Bit) Format Example ...................................11
Decimal Format Example ........................................12
Hexadecimal Format Example .................................13
Programming Conventions Used in this Manual ................14
SYSTEM DELAYS & TIMEOUTS .....................................15
SYSTEM OUTPUT TIMEOUTS ........................................16
DOWNLOAD/CALLBACK OPTIONS ................................16
PAGER FORMAT OPTIONS .............................................16
SYSTEM OPTIONS .....................................................17, 19
CS RECEIVER OPTIONS ................................................20
CS SUBSCRIBER ID OPTIONS .......................................21
CS SYSTEM REPORTING OPTIONS ..............................22
CS AREA & SYSTEM REPORTING OPTIONS ................22
CS ZONE REPORTING OPTIONS ....................................23
CS USER REPORTING OPTIONS ....................................24
EZM GROUP OPTIONS ...................................................25
AREA BELL CONTROL OPTIONS ...................................26
KEYPAD OPTIONS ..........................................................27
TEMPERATURE DISPLAY AT KEYPAD ..........................28
ZONE OPTIONS - ZONES 1 TO 16 .................................29
RF RECEIVER & SUPERVISORY TIMER OPTIONS .......36
CLEAR PROGRAM OPTIONS .........................................37
USER PROGRAM MODE .......................................................37
Preliminary Information ......................................................37
Accessing User Program Mode ..........................................38
User Codes ........................................................................38
Zone Descriptions ..............................................................39
Date ...................................................................................39
Time ...................................................................................39
KEYPAD CONFIGURATION MODE .......................................40
Keypad Installation .............................................................40
Configuring the Keypads ....................................................40
EASY MENU PROGRAMMING WORKSHEETS ....................42
ALPHABETICAL INDEX ..........................................................46
ADDRESS NUMBER INDEX ...................................................51
GEM-P816 WIRING DIAGRAM ...............................................56