15
IP Configuration Settings—Setting IP Configuration of WAN Port
Static IP Settings
NOTE: Complete static IP settings should include a static IP (Option 1 under114
), IP address
(111), Subnet Mask (112), and Default Gateway (113). Please contact your local
Internet Service Provider (ISP) if you have any questions.
Function Command
Select a Static IP
After entering IVR mode, dial 114.
After hearing “Enter value”, dial 1 (to select static IP)
IP address Settings
After entering IVR mode, dial 111. After hearing “Enter value”,
enter your IP address, followed by “#”.
Example: If the IP address is 192.168.1.200, dial 192*168*1*200#.
Subnet Mask Settings
After entering IVR mode, dial 112. After hearing “Enter value”,
enter your subnet mask, followed by “#”.
Example: If the mask value is 255.255.255.0, dial 255*255*255*0#.
Default Gateway
Settings
After entering IVR mode, dial 113. After hearing “Enter value”,
enter your default VoiceCom90’s IP address, followed by “#”.
Example: If the Default Gateway is 192.168.1.254, dial
192*168*1*254#.
Save Settings and
Restart
To save settings, dial 509
(Save Settings). The system will save the
settings. Please restart the system. Wait for about 40 seconds for the
system to restart, and then enter 101
to check if the IP address is
retained. If the IP address is not repeated, it indicates that
VoiceCom90 has not been properly connected, please check if the
cable connection, account, or password are correct.
Dynamic IP (DHCP) Settings
After entering IVR mode, dial 114
.
After hearing “Enter value”, dial 2 (to select DHCP).
Saving settings –press 509
(Save Settings). Please restart the system. After the system is
restarted, press 101 to check if the IP address is retained.
If the system does not repeat the IP address, it indicates VoiceCom90 has not been
properly connected to the Internet. Please check the cable connection.
To Next Page
Loading...
General