National Instruments 8353

Index
© National Instruments Corporation I-7 NI 8352/8353 User Manual
memory upgrades, 1-6
optional equipment, 1-6
overview, 1-6
peripheral expansion overview
(table), 3-1
power source, connecting to, 2-3
rack mounting, 1-6, 2-22
safety and caution notices, 2-1
safety ground, connecting, 2-3
SATA connector locations (figure), B-20
software, 1-7
troubleshooting, 5-1
upgrade information, 4-4
upgrading and replacing hard disk
drives, B-20
upgrading memory, B-13
upgrading RAM, 4-4
USB floppy disk drive, 1-6
using with PXI chassis, 4-2
NI support and services, D-1
NI-DAQmx, 1-7
NI-VISA, 1-8
No Execute Mode Memory Protection, 2-13
Non-RAID, resetting to, C-4
O
Onboard GLAN1/Onboard GLAN2
(Gigabit-LAN) OPROM Configure, 2-10
operating system, installing, 2-28
Option ROM Scan, 2-10
optional equipment, 1-6
memory upgrades, 1-6
rack mount kits, 1-6
USB floppy disk drive, 1-6
OS Boot Watchdog, 2-19
outer slides, installing (figure), 2-24
overview, 1-6
P
Parallel ATA, 2-4
Parallel Port, 2-15
Password on Boot, 2-21
PCI Configuration, 2-10
PCI Express expansion card, installing, B-23
PCI Express slot, B-12
PCI Express Slot pinout (figure), B-12
peripheral expansion overview (table), 3-1
Power Button Behavior, 2-7
power cables (table), 1-2
Power Force On (JPF) jumper settings, B-6
Power Loss Control, 2-8
power saving switch connector (JGS1), B-10
pinout (figure), B-10
power supply, connecting to, 2-3
power up, testing, 2-3
Processor Power Management, 2-14
programming examples (NI resources), D-1
PS/2
connector and signals, 3-2
connector location and pinout
(figure), 3-2
connector signals (table), 3-2
pxisys.ini file, 4-2
Q
QuickBoot Mode, 2-7
Quiet Boot, 2-7
R
rack mounting, 1-6, 2-22
installing chassis into rack, 2-26
installing inner slides, 2-23
installing outer slides, 2-24
installing slide assemblies into rack, 2-25