National Instruments DAQ Series User Manual

© National Instruments Corporation I-1 DAQCard-700 User Manual
Index
Symbols
+5 V signal, 3-3
A
ACH<0..15> signal, 3-2
AIGND signal, 3-2
analog input
specifications, A-1
analog input circuitry
block diagram, 4-5
theory of operation, 4-5
analog input configuration
analog input modes, 2-4
default settings (table), 2-3
DIFF input
configuration, 2-5
definition (table), 2-4
exceeding maximum ratings (caution), 2-3
RSE input
configuration, 2-4
definition (table), 2-4
analog input signal connections
differential (DIFF) connections
common-mode signal rejection
considerations, 3-12
floating signal sources, 3-11
grounded signal sources, 3-10
differential input mode, 3-6
exceeding maximum input rating
(caution), 3-4
floating measurement system, 3-5
floating signal sources, 3-4
ground-referenced measurement
system, 3-5
ground-referenced signal sources, 3-4
input configurations, 3-5
instrumentation amplifier, 3-5
pins for analog input, 3-3
recommended input configurations, 3-7
single-ended connection s, 3-7
single-ended input mode, 3-6
types of measurement systems, 3-4
types of signal sources, 3-4
B
bus interface, A-4
C
cabling, 1-4
CLK, OUT, and GATE signals for
general-purpose timing, 3-16
CLK1 signal, 3-3
CLK2 signal, 3-3
common-mode signal rejection
considerations, 3-12
configuration
analog I/O
analog input modes, 2-4
default settings (table), 2-3
DIFF input, 2-5
exceeding maximum ratings
(caution), 2-3
RSE input, 2-4
counter/timers, 2-5
digital I/O, 2-5
input configurations
differential input mode, 3-6
instrumentation amplifier, 3-6
recommended input configurations
(table), 3-7
single-ended input mode, 3-6

National Instruments DAQ Series Specifications

General

Brand	National Instruments
Model	DAQ Series
Category	Recording Equipment
Language	English