National Instruments DAQ Series User Manual

Index
© National Instruments Corporation I-3 DAQCard-700 User Manual
general-purpose counter and timing
connections
event-counting applications (figure), 3-17
figure, 3-19
frequency measurement (figure), 3-18
pulse and square wave generation, 3-16
pulse-width measurement, 3-17
time-lapse measurement, 3-17
timing specifications, 3-19
ground-referenced measurement system, 3-5
ground-referenced signal sources
definition, 3-4
differential connections, 3-10
recommended input configurations
(table), 3-7
I
I/O connector
exceed maximum ratings (caution), 3-1
pin assignments (figure), 3-2
input configurations
DIFF
definition (table), 2-4
purpose, 2-5
differential mode, 3-6
instrumentation amplifier (figure), 3-5
recommended input configurations, 3-7
RSE
definition (table), 2-4
purpose, 2-4
single-ended mode, 3-6
installation, DAQCard-1200, 2-1
instrumentation amplifier
figure, 3-5
purpose and use, 3-6
M
measurement systems
floating, 3-5
ground-referenced, 3-5
multichannel (scanned) data acquisition, 4-7
N
National Instruments documentation, viii
National Instruments Web support, E-1
NI Developer Zone, E-1
O
operation of DAQCard-700
See also theory of operation
OUT, GATE, and CLK signals for
general-purpose timing, 3-16
OUT0 signal, 3-3
OUT1 signal, 3-3
OUT1* signal, 3-3
OUT2 signal, 3-3
P
PC-LPM-16, compared with
DAQCard-700, B-1
PCMCIA
I/O channel interface circuitry, 4-3
physical specifications, A-4
power connections, 3-14
power requirement specifications, A-4
pulse and square wave generation, 3-16
pulse-width measurement, 3-17

National Instruments DAQ Series Specifications

General

Brand	National Instruments
Model	DAQ Series
Category	Recording Equipment
Language	English