Index
DAQCard-700 User Manual I-4 ni.com
R
referenced single-ended input. See RSE input
RSE input
configuration, 2-4
definition (table), 2-4
S
signal connections
analog input signal connections
differential (DIFF) connections
common-mode signal rejection
considerations, 3-12
floating signal sources, 3-11
grounded signal sources, 3-10
differential input mode, 3-6
exceeding maximum input rating
(caution), 3-4
floating measurement system, 3-5
floating signal sources, 3-4
ground-referenced measurement
system, 3-5
ground-referenced signal
sources, 3-4
input configurations, 3-5
instrumentation amplifier, 3-5
pins for analog input, 3-3
recommended input
configurations, 3-7
single-ended connections, 3-7
single-ended input mode, 3-6
types of measurement systems, 3-4
types of signal sources, 3-4
cabling, 1-4
digital I/O signal connections, 3-13
I/O connector
exceed maximum ratings
(caution), 3-1
pin assignments (figure), 3-2
power connections, 3-14
signal descriptions, 3-2
timing connections
data acquisition counter and timing
connections, 3-15
general-purpose counter and timing
signal connections, 3-16
single-channel data acquisition, 4-7
single-ended connection considerations
connecting signal source (figure), 3-8
when to use, 3-7
single-ended input mode, 3-6
specifications
analog input, A-1
bus interface, A-4
digital I/O, A-2
physical, A-4
power requirement, A-4
timing I/O, A-3
square wave generation, 3-16
system integration, by National
Instruments, E-1
T
technical support resources, E-1
theory of operation
analog input circuitry, 4-5
block diagram, 4-2
data acquisition timing circuitry, 4-6
data acquisition rates, 4-7
multichannel (scanned) data
acquisition, 4-7
single-channel data acquisition, 4-7
major components, 4-1
PCMCIA I/O channel interface
circuitry, 4-3
time-lapse measurement, 3-17
timing connections
data acquisition counter and timing
connections, 3-15
EXTCONV* signal timing
(figure), 3-15
To Next Page
Loading...
