National Instruments SCB-68A - Chapter 1; Getting Started with the SCB-68 A

© National Instruments | 1-1
1
Getting Started with the
SCB-68A
The SCB-68A, shown in Figure 1-1, is a shielded I/O connector block with 68 screw terminals
for easy signal connection to a National Instruments 68-pin or 100-pin DAQ device.
Figure 1-1. SCB-68A Parts Locator Diagram
The SCB-68A features a general breadboard area for custom circuitry and through hole pads for
interchanging electrical components. These through hole pads allow filtering, 4 to 20 mA
1 Top Cover (Required)
2 Quick Reference Label
3 Enclosure Base
4 Strain-Relief Screws
5 Strain-Relief Bar
6 SCB-68A Board Assembly
4
5
4
1
2
3
6