EasyManuals Logo

National Instruments SCXI Series Getting Started

National Instruments SCXI Series
158 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #155 background imageLoading...
Page #155 background image
Index
Getting Started with SCXI I-6 www.ni.com
configuring, 3-58
SCXI-1001 chassis
configuring, 3-58
SCXI-1100 module
configuration and jumper settings, 3-4
filtering, 3-5
input signal referencing mode, 3-4
PGIA output referencing modes, 3-6
when to change factory settings, 3-4
problems and solutions
cable assembly, A-4
ground-referenced signals, A-2
LabVIEW software, A-2
setting gain for continuous gain
acquisition, A-3
thermocouples, A-3
thermocouples, 4-7
SCXI-1102/B/C module
configuration and jumper settings, 3-7
thermocouples, 4-8
SCXI-1112 module
configuration, 3-8
thermocouples, 4-8
SCXI-1120/D module
configuration and jumper settings, 3-8,
3-9
connecting MISO signal
to SERDATOUT pin, 3-14
filtering, 3-11
gains, 3-9
signal output referencing, 3-13
temperature sensor signal routing,
3-13
when to change factory settings, 3-9
filtering
filter jumper allocation (table), 3-12
filter jumper allocations (table), 3-11
gain
gain jumper allocation (table), 3-9
gain jumper positions (table), 3-10
temperature sensor signal routing
signal referencing jumper
configuration (table), 3-14
thermocouples, 4-8
SCXI-1121 module
configuration and jumper settings, 3-14
connecting MISO signal to
SERDATOUT pin, 3-23
enabling half-bridge completion
network, 3-21
excitation levels, 3-19
excitation mode, 3-17
filtering, 3-16
gain selection, 3-15
signal output referencing, 3-23
when to change factory settings, 3-15
connecting to RTDs (figure), 4-21
thermocouples, 4-8
SCXI-1122 module
configuration and jumper settings, 3-23
grounding, shielding, and reference
mode selection, 3-25
current-loop receivers, 3-25
excitation channel signal connections,
4-22
connecting quarter-bridge strain
gauge (figure), 4-23
exceeding overvoltage protection
or isolation rating (warning), 4-22
excitation level, 4-22
maximum load per excitation
channel (table), 4-22
using internal half-bridge
completion, 4-23
overview and features, 3-23
scanning techniques, 3-25
thermocouples, 4-8
SCXI-1124 module
analog output channel signal connections,
4-28
connecting DAC channel as voltage
output (figure), 4-29

Table of Contents

Other manuals for National Instruments SCXI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the National Instruments SCXI Series and is the answer not in the manual?

National Instruments SCXI Series Specifications

General IconGeneral
BrandNational Instruments
ModelSCXI Series
CategoryControl Unit
LanguageEnglish

Related product manuals