National Instruments SCXI Series Getting Started

Index
© National Instruments Corporation I-7 Getting Started with SCXI
current loop connection, load and
external supply grounded (figure),
4-31
DAC channel connection as current
output
external loop supply (figure),
4-30
internal loop supply (figure),
4-29
configuration and jumper settings, 3-26
setting for specific DAQ device, 3-27
single or multichassis system, 3-27
SCXI-1125 module
configuration, 3-28
thermocouples, 4-8
SCXI-1126 module
configuring, 3-29
SCXI-1140 module
configuration and jumper settings, 3-29
connecting MISO signal to
SERDATOUT pin, 3-32
DAQ device connections in
multiple-module systems, 3-29
gain selection, 3-31
instrumentation amplifier output
referencing mode, 3-30
signal referencing mode, 3-30
user-configurable jumpers and DIP
switches, 3-29
connecting to DAQ device, A-4
SCXI-1141/1142/1143 module configuration
and jumper settings, 3-32
chassis jumper configurations (table),
3-33
grounding and shielding jumper
configurations (table), 3-34
when to change factory settings (note),
3-32
SCXI-1160 module configuration and jumper
settings, 3-38
SCXI-1161 module configuration and jumper
settings, 3-38
SCXI-1162 module
configuration and jumper settings, 3-39
device type selection, 3-41
parallel lines selection, 3-40
parallel or serial mode selection, 3-40
when to change factory settings
(note), 3-39
problems and solutions, A-5
SCXI-1162HV module configuration and
jumper settings, 3-42
SCXI-1163 module
configuration and jumper settings, 3-44
device type selection, 3-45
serial or parallel mode selection, 3-45
when to change factory settings
(note), 3-45
problems and solutions, A-5
SCXI-1163R module configuration and
jumper settings, 3-47
SCXI-1180 feedthrough panel, 3-56
SCXI-1181 breadboard module, 3-56
SCXI-1200 module
analog I/O configuration, 3-51
analog input configuration, 3-52
DIFF input, 3-53
input configurations (table), 3-52
NRSE input, 3-53
RSE input, 3-53
analog input polarity and range, 3-54
analog I/O settings (table), 3-51
factory settings, 3-51
jumper settings (table), 3-54
analog output configuration, 3-52
front connector pin assignments (figure),
3-55
LabVIEW problems, A-2
module configuration, 3-51
overview, 3-50
parallel port interface, 3-50
SCXI-1320 terminal block (figure), 4-20
SCXI-1321 terminal block (figure), 4-10

National Instruments SCXI Series Specifications

General

Brand	National Instruments
Model	SCXI Series
Category	Control Unit
Language	English