National Instruments SCXI Series Getting Started

Chapter 4 Connecting and Using Accessories and Transducers
© National Instruments Corporation 4-3 Getting Started with SCXI
SCXI-1140
SCXI-1141
SCXI-1142
SCXI-1143
SCXI-1301
SCXI-1304
SCXI-1305
SCXI-1310
No
No
No
No
No
No
No
No
Used with
SCXI-1140 only
AC/DC coupling
AC/DC coupling
Low-cost
connector and shell
SCXI-1160 SCXI-1324 No No —
SCXI-1161 — No No —
SCXI-1162
SCXI-1162HV
SCXI-1163
SCXI-1163R
SCXI-1326
TBX-1326
No
No
No
No
—
—
—
—
SCXI-1180 SCXI-1302 No No —
SCXI-1181 SCXI-1301
SCXI-1310
SCXI-1330
1
No
No
No
No
No
No
—
—
—
SCXI-1200
2
SCXI-1302 No No —
SCXI-1520 SCXI-1314 Yes No Quarter-bridge
completion, shunt
calibration
resistors
SCXI-1530
SCXI-1531
— No No —
SCXI-1540 SCXI-1315 No No —
All modules TBX-24F
3
No No —
1
The SCXI-1330 connector is keyed for use with high-voltage modules. To use the SCXI-1330 with the
SCXI-1181, you must remove the keys by sliding the two coding wedges from their dovetail grooves. The
SCXI-1181 is not intended for use with hazardous voltages (exceeding 42 V
rms
). National Instruments is not
liable for damages or injuries resulting from improper installation.
2
To connect signals to the SCXI-1200, you can also use a CB-50, a CB-50LP, a BNC-2081, or an SC-2071.
3
The TBX-24F is a general-purpose feedthrough connector that mounts on a DIN rail.
Table 4-1. SCXI Module and Connector Compatibility (Continued)
Module
Terminal/
Connector
Features
Cold-Junction Sensor Isothermal Others

National Instruments SCXI Series Specifications

General

Brand	National Instruments
Model	SCXI Series
Category	Control Unit
Language	English