Native Instruments Komplete Audio 6 User Manual

Digital Sync Source Section
The Digital Sync Source section in the Audio Settings page of the Control Panel.
In the Digital Sync Source section, you can select whether the device uses its internal clock or
gets synchronized to the clock of an external device:
▪ Internal (standard setting): Leave this radio button selected if you don't want the device to
be synchronized to the clock of an external device.
▪ External S/PDIF 5|6: Select this radio button if you want the device to be synchronized to
the clock of another external device via S/PDIF. When switching to this setting, the device
automatically tries to establish synchronization to an external clock at the digital input/out-
put 5 and 6 (see also chapter ↑4.2, Rear Panel). If the synchronization request fails, the
interface switches back to internal clock mode. If the synchronization is successful, the top
panel’s Sync LED lights (see chapter ↑4.3, Top Panel).
Direct Monitoring Section
The Direct Monitoring section in the Audio Settings page of the Control Panel.
In the Direct Monitoring section, you can set the device to bypass any signal processing and
send the signal from the input directly to the output of the device (at zero latency).
This function can be accessed from the MONITOR section on the device's front panel
too; see chapter ↑4.1, Front Panel for further information.
The Direct Monitoring section has a button and a drop-down menu:
Advanced Configuration
Advanced Configuration on Windows (Control Panel)
KOMPLETE AUDIO 6 - Manual - 26

Native Instruments Komplete Audio 6 Specifications

General

Brand	Native Instruments
Model	Komplete Audio 6
Category	Recording Equipment
Language	English