Native Instruments Komplete Audio 6 User Manual

For information on how to record in your audio recording software, please refer to your
software's documentation.
6.3.3 Connecting a Guitar / Bass Guitar (with headphones)
KOMPLETE AUDIO 6 setup with guitar / bass guitar and headphones.
Make sure to have connected the KOMPLETE AUDIO 6 to your computer as described during
the installation chapter (chapter ↑2, Installing KOMPLETE AUDIO 6) of this manual.
To use the KOMPLETE AUDIO 6 in a recording setup with a guitar / bass guitar:
1. Turn the Volume Control knob (MAIN VOLUME 1/2) on the top panel of the KOMPLETE
AUDIO 6 to the left-end stop to set the volume to minimum.
2. Plug a 1/4" instrument cable (unbalanced) from your instrument into either INPUT 1 or
INPUT 2 of the KOMPLETE AUDIO 6.
Using the KOMPLETE AUDIO 6 (Setup Scenarios)
KOMPLETE AUDIO 6 in a Recording Setup
KOMPLETE AUDIO 6 - Manual - 41

Native Instruments Komplete Audio 6 Specifications

General

Audio Resolution	24-bit/192kHz
Power Supply	USB bus powered
Audio Interface Type	USB
Simultaneous I/O	6 x 6
Number of Preamps	2
A/D Resolution	24-bit/192kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Phantom Power	Yes
Digital Inputs	1 x Coax (S/PDIF)
Digital Outputs	1 x Coax (S/PDIF)
Headphone Output	1 x 1/4" TRS
Software Included	Komplete Elements
Outputs	4 x analog (2 x TRS, 2 x RCA)