3. Make sure the LINE/INST button adjacent to the jack is set to INST (for instruments with
active electronics, set this to LINE).
4. Plug the 1/4" TRS jack of your headphone cable into the PHONES socket on the KOM-
PLETE AUDIO 6's front panel. Turn the Volume Control knob (VOLUME) in the headphone
section of the KOMPLETE AUDIO 6 to the left-end stop to set the volume to minimum.
5. Open the audio preferences of your audio recording software, and select KOMPLETE AU-
DIO 6 as your input and output device (you may have to restart your host software for the
changes to become active). Refer to the documentation of your audio recording software
for information on how to configure the audio device setup.
6. Make sure that the Volume knob on your instrument is at maximum.
7. While playing your instrument, adjust the input signal by turning the relevant input chan-
nel's GAIN knob gradually to the right. Check the input LEDs (INPUT 1 and 2 LEDs on
the top panel of the KOMPLETE AUDIO 6) to make sure your input signal does not clip;
adjust the input level so that the LEDs lights green on input. A red lighting LED indicates
signal clipping.
8. Gradually turn the Volume Control knob (VOLUME) in the headphone section of the KOM-
PLETE AUDIO 6 to the right until you reach a good listening level.
Using the KOMPLETE AUDIO 6 (Setup Scenarios)
KOMPLETE AUDIO 6 in a Recording Setup
KOMPLETE AUDIO 6 - Manual - 42
To Next Page
Loading...
Need help?
General
