EasyManuals Logo

Native Instruments Komplete Audio 6 User Manual

Native Instruments Komplete Audio 6
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background image
3. Turn your stereo amplifier / mixer on.
4. Turn the Volume Control knob (MAIN VOLUME 1/2) on the top panel of the KOMPLETE
AUDIO 6 to the right-end stop to set the output to its maximum level.
5. Start the playback of an audio file on your computer.
6. Gradually raise your stereo console's / mixer's volume control level until you reach a good
listening level.
6.2 Connecting Headphones
KOMPLETE AUDIO 6 setup with headphones.
Make sure the KOMPLETE AUDIO 6 is connected to your computer as described during the
installation chapter (chapter 2, Installing KOMPLETE AUDIO 6), and configured as your com-
puter's main audio output device (see chapter 3, Basic Configuration).
To use headphones with your KOMPLETE AUDIO 6:
Using the KOMPLETE AUDIO 6 (Setup Scenarios)
Connecting Headphones
KOMPLETE AUDIO 6 - Manual - 35

Table of Contents

Other manuals for Native Instruments Komplete Audio 6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Native Instruments Komplete Audio 6 and is the answer not in the manual?

Native Instruments Komplete Audio 6 Specifications

General IconGeneral
Audio Resolution24-bit/192kHz
Power SupplyUSB bus powered
Audio Interface TypeUSB
Simultaneous I/O6 x 6
Number of Preamps2
A/D Resolution24-bit/192kHz
MIDI I/O1 x MIDI In, 1 x MIDI Out
USBUSB 2.0
Phantom PowerYes
Digital Inputs1 x Coax (S/PDIF)
Digital Outputs1 x Coax (S/PDIF)
Headphone Output1 x 1/4" TRS
Software IncludedKomplete Elements
Outputs4 x analog (2 x TRS, 2 x RCA)

Related product manuals