Native Instruments Komplete Audio 6 User Manual

6 Using the KOMPLETE AUDIO 6 (Setup Scenarios)
In this chapter, you will learn how to connect the KOMPLETE AUDIO 6 in various setup sce-
narios. Although we cannot cover all imaginable setups here, the examples are general enough
to apply the information to most situations.
Please make sure to have installed the KOMPLETE AUDIO 6 driver as described in
chapter ↑2, Installing KOMPLETE AUDIO 6 prior to connecting the KOMPLETE AU-
DIO 6 to your computer. The device will not work properly otherwise.
6.1 Connecting Speakers
6.1.1 Connecting Active Monitor Speakers
KOMPLETE AUDIO 6 setup with active monitors.
Make sure the KOMPLETE AUDIO 6 is connected to your computer as described during the
installation chapter (chapter ↑2, Installing KOMPLETE AUDIO 6), and is configured as your
computer's main audio output device (see chapter ↑3, Basic Configuration).
To use active speakers (self-powered speakers with a built-in amplifier) with your KOMPLETE
AUDIO 6:
Using the KOMPLETE AUDIO 6 (Setup Scenarios)
Connecting Speakers
KOMPLETE AUDIO 6 - Manual - 33

Native Instruments Komplete Audio 6 Specifications

General

Audio Resolution	24-bit/192kHz
Power Supply	USB bus powered
Audio Interface Type	USB
Simultaneous I/O	6 x 6
Number of Preamps	2
A/D Resolution	24-bit/192kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Phantom Power	Yes
Digital Inputs	1 x Coax (S/PDIF)
Digital Outputs	1 x Coax (S/PDIF)
Headphone Output	1 x 1/4" TRS
Software Included	Komplete Elements
Outputs	4 x analog (2 x TRS, 2 x RCA)